Addonics Technologies ADSAIDE44 Uživatelský manuál stáhnout pdf

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

Installation Guide

Front View

Jumper Settings

Master Slave Cable Select

Note: To set the SATA hard drive as a Master Device

when connected to an IDE channel, you need to

short the top pins located on the converter by

placing a jumper. As a Slave Device short the

middle pins.

1. Locate the SATA connector of your 2.5” SATA drive.

2. Connect the converter board to the SATA connector of

the hard drive.

3. (Optional) Connect the IDE ribbon cable to the 44-pin

connector on the converter. The red edge of the ribbon

cable needs to line up to pin 1 marker of the 44-pin

connector. The other end of the ribbon cable will be

connected to your motherboard’s 44-pin IDE channel.

TECHNICAL SUPPORT

Email: http://www.addonics.com/sales/

Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)

Phone: 408 573-8580

Email: http://www.addonics.com/support/ticketid/

44-pin IDE Connector

SATA Power and

Data Connector

Master, Slave &

Cable Select

Jumpers

Pin 1 Marker

15-pin SATA Power &

7-pin Data Connector

ADDONICS TECHNOLOGIES Model: ADSAIDE44 Installation Guide Front View Jumper Settings Master

Žádné komentáře

Addonics Technologies ADSAIDE44 Uživatelský manuál