Addonics Technologies ADI2S3GPX1-2E Uživatelský manuál stáhnout pdf

Addonics

T E C H N O L O G I E S

SATA/IDE RAID PCI-E Controller

Model: ADI2S3GPX1-2E

User’s Guide

Version 1.0

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital

device pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy. If not installed and

used in accordance with the instructions, it may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If the equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment on and off, the user

is encouraged to try and correct the interference by one or more of the following

suggestions.

Reorient or relocate the receiving antenna

Increase the distance between the equipment and the receiver

Connect the equipment to a different power outlet other than the one where receiver is

connected

Consult a certified television or radio technician

Overview

Note: The IDE devices attach to the IDE channel must be set as a master and

slave pair.

Note: There are four SATA ports in SATA/IDE RAID PCI-E controller card.

These ports are named CON1 to CON4. Ports CON3 & CON4 are

eSATA ports and CON1 & CON2 are internal SATA ports. Changing the

jumper setting on the SATA/IDE RAID PCI-E Controller card allows

you to select between eSATA and internal SATA ports. By default, ports

CON1 & CON2 are enabled.

IDE Channel

eSATA

Ports

Internal

SATA ports

CON1

Jumper Pins

CON2

CON4

CON3

1 2 3 4

Addonics 1
ADI2S3GPX1-2E. Use the 2

Shrnutí obsahu

Strany 1 - Addonics

Addonics T E C H N O L O G I E S SATA/IDE RAID PCI-E Controller Model: ADI2S3GPX1-2E User’s Guide Version 1.0 FCC Warning Stat

Strany 2 - ADI2S3GPX1-2E. Use the

Detailed View of Jumper Pins To enable CON3 and disable CON1, transfer jumper to pins 2 & 3 on J1, J2, J3 & J4 To enable CON4 and disable

Strany 3

Delete RAID Disk Drive 1. Press Ctrl+J when prompted to enter the RAID BIOS. 2. At the next screen select Delete RAID Disk Drive, press Enter. 3. U

Strany 4

Driver Installation For A New Fresh Windows Install A new installation requires a floppy disk for the driver installation. To make this floppy disk, c

Komentáře k této Příručce

Žádné komentáře

Addonics Technologies ADI2S3GPX1-2E Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Řadiče RAID Addonics Technologies ADI2S3GPX1-2E. Addonics Technologies ADI2S3GPX1-2E User's Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Řadiče RAID Addonics Technologies ADI2S3GPX1-2E